Latest Posts
-
Waveshare 2-channel Ethernet to RS-485 gateway insides
Yet another Waveshare teardown because, yeah, I like their stuff. This time it’s a 2-channel ethernet to RS-485 gateway. As with all their other stuff there’s some serious input protection there, a TVS across the RS485 inputs feeding Sharp PC817… Continue reading
-
Alarm Redo, Part 6
The rest of the setup involves connecting the hardware to Home Assistant. The KC868 comes with MQTT support so you can just feed that directly into HA, with the data being found at KC868_A16/[mac_address]/STATE for the v2 board and A16v3/[mac_address]/STATE… Continue reading
-
Einhell / Ozito Power X Change battery pack teardown, 2025 update
Another brief update on the original teardown post, this time not with new batteries but new information, namely the TÜV SÜD test report on the Einhell batteries which contains fairly comprehensive information on the Einhell packs. Not the same one… Continue reading
-
Register Map for CDEbyte Devices
CDEbyte make quite a number of useful modbus devices, unfortunately the documentation for these contain a plethora of insects because they’re usually copied from other docs with values adjusted to be off by one because of the zero-based/one-based ambiguity of… Continue reading
-
Alarm Redo, Part 5
The final part of the rewiring consisted of installing the keypad covered in this post. This just involved taking the existing setup and mounting it on the wall. The first step was temporarily mounting it on a block of ply… Continue reading
-
Alarm Redo, Part 4
With all the wiring from the previous part tested tested it was time to put the alarm back on the wall. This is just the setup from the previous part with the huge mass of alarm wiring pulled through the… Continue reading
-
Adding Temperature Monitoring to a Hot Water Cylinder
I wanted to add temperature monitoring to my HWC for better integration into the solar ESS, so I could dump excess power into the HWC. This coincided with a failed element on the existing HWC, since this was over 40… Continue reading
-
Wiring up a DHT11 / DHT22 Temperature Sensor
If you can’t solder these directly into whatever board you’re using then they’re a bit of a pain to wire up since you need to attach three wires to pins with very close spacing, and can’t apply too much heat… Continue reading
-
Alarm redo, Part 3
With all the sensors tested I could take the alarm enclosure off the wall and move it onto the workbench for further work, since it was going to require a fair bit of work. First thing was to mount the… Continue reading
-
Alarm Redo, Part 2
A side-effect of ripping out the old alarm (see this post) is that I needed to replace the keypad by the entrance. There’s an infinite number of these on AliExpress, with various combinations of { PIN, RFID, phone NFC, fingerprint… Continue reading
